5D Light Up LED Chevy Emblem Tail Lights

LED Chevy Emblem Light Description:

✅【Applicable to Chevy】This product has the same appearance as the original car standard, and can be installed in the trunk of the car to directly replace the original car standard. Its special vacuum plating technology ensures not only the same gloss as the original logo, but also high transparency and uniform brightness.

✅【High Quality】Adopting high quality LED light set, high brightness and long service life. Special waterproof and dustproof design to ensure long-term use.

✅【Unique design】This product is designed for car modification enthusiasts. When the lights are not lit during the day, there is no difference with the original car mark. When the license plate lighting is on at night, the LED lights will also light up, making the marker dazzling at night, rich in future technology and highlighting the noble bloodline of your car.

✅【Easy to install】Using high-quality double-sided adhesive for cars, strong and durable! Built-in LED lights, especially waterproof and dustproof! The life of LED lights up to 100,000 hours.

LED Chevy Emblem Light Feature:

Voltage:12 (V)
Size:  6.7×2.2 inch (170×55 mm).

(Please check the size before you buy and see if it fits your car!!!)

We will not accept the return back due to the wrong size.

Wiring length: 0.6 meters

Material: ABS plating, 3M glue at the bottom

Package Contents:1* LED Chevy Emblem

【LED Chevy Emblem Installation Notes】

[Tools prepared before installation] Please have the following tools ready before you start:

(1. Flat head screwdriver 2. Phillips screwdriver 3. Insulating tape 4. Towel 5. Pliers)

1. First, place the towel next to the tail door sign and shake the sign with a flat screwdriver to prevent the towel from scratching the body.

2. Take off the double-sided adhesive tape first. Squatting should be moderate, not too fierce.

Later, slowly squat down to clean the sticker and the double-sided adhesive.

3. Remove the partition board inside the trunk using a Phillips screwdriver. Note that there are clips in some places. Pay attention to remove the baffle, see the various lines.

4. Now install the label light, and the power cord of the label light passes through one of the label positioning holes.
And put on the back of the label light in the trunk of the car. While pulling the wire, glue the label light to the body and press it tightly.

5. The beacon light has been installed and is now connected to the power supply. The lights should be connected to the power supply of the license plate, so that when the night light is on, the lights will also be on. Find the power port of the rear license plate light.

Notes：
Due to the light and screen setting difference, the item’s color may be slightly different from the pictures.